FACT:  Our pump housings are machined from bar stock and are thick walled. Many competiitors use cast housings, which require thinner wall designs to minimize shrinkage and cracking upon cooling.

RESULT: Our pumps can handle higher system pressures. Additionally, they provide a greater safeguard against unforeseen pitting and general corrosive attack.

FACT: Our G3000 and higher series of gear pumps utilize two housings to retain the bearings, shafts, gears, and wearplates. Competitive pumps utilize three or more housings.

RESULT: With two precisely machined housings, the probability of bearing misalignment and accelerated wear is greatly reduced.   

2)  G3000 and G4000 Series for metering various solvents, including MEK, Methanol, Diacetone Alcohol, and Butylacetate for an ink manufacturer; manual control; replaced competitor's gear pumps which could not handle the low viscosities. 

3)  G3000 Series for metering herbicides in a pilot plant; pump incorporated flush plugs and a drain plug to clean the pump without disassembly; manual control; pump was mounted to an air motor.

4)  G3000 Series for metering pigment which included titanium dioxide; differential pressure 15 PSI; .02 GPM; mounted to a 4:1 ratio in-line gear reducer.

5)  G3000 Series for metering 25% Sodium Hydroxide for a scrubber system; external control via 4-20 mAmp signal; replaced a hose pump due to chronic hose failures.                                                                                                                                               6)  G4000 Series for transferring hot vegetable oil at 275°F; pump was heat traced to prevent solidification of oil when pump was not in use.                                                                                                                                                                                       7)  G4000 Series for metering 50% sodium hydroxide for a wastewater neutralization system; system uses on-off control; self-priming up to 10'  required.                                                                                                                                                                 8)  G4000 Series for metering 75% Phosphoric Acid at a remediation site; external control via 4-20 mAmp signal.

9)  G4000 Series for metering 2 Megohm de-ionized water; differential pressure 80-100 PSI; up to 12 GPH; external control via 4-20 mAmp signal; mounted to a 2:1 ratio in-line gear reducer.

10) G4000R Series for metering up to 15% Sodium Hypochlorite at various municipal waste water treatment facilities. Flows ranged from 40 to over 1000 gallons per day; manual and external controls; replaced diaphragm metering pumps from several manufacturers.

11) G4000R Series for metering 32% hydrochloric acid for a PH control system; differential pressure 10-20 PSI; .5 GPM.

12) G3000 and G4000 Series for metering detergent from drums into a water stream for commercial truck wash systems.

13) G5000 Series for metering polymer for a water treatment plant in a steel mill.

14) G5000 Series for recirculating glycol solution as a barrier fluid for a double mechanical seal; suction pressure 700 PSIG; differential pressure 40 PSI; 5 GPM.

15) G5000 Series for transferring hot vegetable oil at 240°F; pump was heat traced to prevent solidification of oil when pump was not in use.

16) G5000 Series for metering 1-1.5 GPM dielectric oil under 29" Hg vacuum.

17) G6000 Series for metering polymer in a chemical plant.